Descripción

Inline pressure regulator, 2 x IT, without secondary venting, G 1/4, AF 17, Working pressure (pre-set) 1 bar, PN max. 18 bar. This single-acting diaphragm regulator can be installed in any pneumatic system. Since the pressure is preset in the factory and cannot be altered, the product is also tamper-proof.We recommend mounting the regulator directly on the tool to make sure the correct pressure is applied. In this case, the tool is never stressed by the higher pressure of the supply system and is protected against pressure fluctuations in hoses, pipes, etc.Energy efficiency and economic efficiency can be achieved by using an inline pressure regulator.
A [mm]34.0
B [mm]52.0
Flow rate [l/min]400
Flow rate measurement At P1 = 12 bar and pressure drop ?p = 0.5 bar
Housing Zinc
Internal parts Brass, NBR, stainless steel
Max. operating pressure [bar]18
Max. temperature range [°C]60
Min. temperature range [°C]0
Page No. HK175
Series inline
Thread G 1/4
Working pressure (preset) [bar]1.0
a/f [mm]17
''